Description
Relay is a relay sensor. It can be used in isolation control.
*Compatible with the DIY and mCookie series.
Introduction of Pins
Servo Relay
General Pin Out
Sensor / Trinket’s Pin Out
PIN1 (GND)
GND
PIN2 (VCC)
VCC
PIN3 (SIGNAL-A)
Digital Output
PIN4 (SIGNAL-B)
Not Connected
General Pin Out is the standard pin out of a Sensor / Trinket connector.
Sensor / Trinket’s Pin Out is this specific Sensor / Trinket’s wiring in relation to the General Pin Out.
SIGNAL-A / SIGNAL-B are signals that could be digital input, digital output, analog input or analog output. Or special signals such as serial communication (SoftwareSerial, IIC (I2C), etc) or other special signals.
Not Connected refers to the Pin not being used for this particular Sensor / Trinket.
Read more about the hub module.
Features
Used in isolation control of high voltage and high current signal.
With small size which is easy to install.
Specification
Voltage
Primary side input 5V working voltage
Secondary side output 10A 250VAC/10A 30VDC
Size
Size of the board:
1.27mm-spacing 4Pin interface connected with sensorhub
Function description
Use relay to control the output of a larger voltage.
Connection
This sensor can be connected to the following interfaces of core: D2~D13,A0~A7
